LIGER™ Belt Sizing Instructions

LIGER™ belt sizing is based on ACTUAL WAIST CIRCUMFERENCE in inches.

Each belt is handmade one at a time upon receipt of order based on the sizing information you provide.

In order to prevent ordering an incorrect size and to insure a tailored fit, please carefully read the following simple measuring instructions:

1. Do NOT order according to your pants size. Please measure your waist circumference in inches with a cloth tailor's tape (or a measuring tape).
2. Put the tape through the loops on your pants as you would usually wear them, measuring all the way around your waist with any equipment you wear on your belt or inside your waist band like guns, knives, phones, pouches, etc.
3. This waist circumference measurement is your belt size and should be the location of your primary hole. If you measure an odd number (ex: 41 inches), order the next higher even number size (Size 42).
4. Each belt comes with six (6) pre-punched holes. Besides your primary hole, Maxpedition provides two additional holes going smaller and three additional holes going larger at one (1") inch increments for fine adjustment.
5. Each belt is custom built to order and components are permanently rivetted together, consuming the components and rendering them impossible to reuse.

Product Warranty

Maxpedition extends a limited lifetime warranty covering all products against manufacturers defects including flaws in material and workmanship. Products covered under our warranty will be repaired or replaced at Maxpedition's discretion, free of charge. This limited lifetime warranty does not cover misuse, abuse, or normal wear and tear.